Emergency Service, Day or Night — Call (415) 738-4058
Fresh Air Chimney Sweep Cleaning

Chimney Sweep FAQ — Redwood City, CA

Common questions from homeowners in Redwood City and the surrounding area. If your question isn't here, call us and we'll give you a straight answer.

How often does a Redwood City chimney actually need sweeping?

Use drives it more than the calendar does. Our heating season here is short, realistically mid-November through February, and a lot of fireplaces get lit a dozen evenings a year for ambiance rather than heat. A fireplace used that lightly often needs an annual look and a sweep every second or third year, while one burning most winter nights wants a sweep every season. Wet or resinous wood, slow smoldering fires, and a short flue all speed up buildup, so we go by what we find inside, not by a rule.

Call (415) 738-4058 for a same-day estimate.

Walk me through a sweep and inspection visit from the door to the cleanup.

We start by looking at the room side: hearth, firebox, damper, surround, and how the opening is sized. Then drop cloths go down, the HEPA vacuum gets running at the opening, and we brush the flue from the appropriate end with rods and the right brush for the liner type. After the sweep we check the smoke chamber, the smoke shelf, the damper seat, the cap and crown, and the top of the flue. You get the findings in plain language, with photos of anything we want you to see for yourself.

Call (415) 738-4058 for a same-day estimate.

How is the yearly check different from the inspection done for a home sale?

The yearly check is a visual and physical look at the parts we can reach, paired with the sweep. The fuller inspection is what you want when a Redwood City house is changing hands, after an earthquake or a chimney fire, or when the appliance or fuel type has changed. That one goes further into the flue interior, the liner joints, and clearances where the chimney passes through framing, often with a camera run down the flue. Older downtown-grid homes with clay tile liners are the ones where that deeper look most often turns something up.

Call (415) 738-4058 for a same-day estimate.

How long will you be here, and will my living room be a mess?

A straightforward sweep and inspection usually runs about an hour to ninety minutes. Add time if there is heavy buildup, a difficult cap, a steep roof, or a gas unit that needs the glass pulled and the burner cleaned. Containment is the whole job: drop cloths over the hearth and flooring, a sealed vacuum pulling at the opening the entire time we brush, and shoe covers inside. We haul out the debris, and the room should look the way it did when we arrived.

Call (415) 738-4058 for a same-day estimate.

What warning signs mean it is time to stop burning and get us out there?

Smoke rolling back into the room, a fire that will not get going, or a draft that reverses when the house is closed up all point at a blocked or compromised flue. In warm weather, a sour or campfire smell drifting out of the opening is the fog and humidity working on creosote inside. Also call on dark staining on the brick or ceiling near the chimney, water marks after a winter storm, a cap that is rusted through or gone, and scratching, chirping, or nest material above the damper. Any of those, leave the fireplace cold until it has been looked at.

Call (415) 738-4058 for a same-day estimate.

What is creosote, and why does a hard-used flue build it so much faster?

Creosote is the tar and condensed smoke that sticks to the flue wall when wood gas cools before it clears the top. It starts as soot, layers into a crust, and in the worst cases hardens into a shiny glaze. Burn more fires and you push more of that material up the flue, so a chimney lit most winter nights builds faster than a neighbor's lit six times. Unseasoned wood, damped-down smoldering fires, and an exterior chimney on the cold north side of the house all make it worse because the smoke cools sooner.

Call (415) 738-4058 for a same-day estimate.

My neighbor has an open brick fireplace and I have a sealed gas insert. Do they need the same thing?

No. An open masonry fireplace with clay flue tile, common in the 1910s–1940s bungalows and Spanish Revival homes near downtown, needs brushing, a creosote check, and attention to the damper, smoke chamber and cap. A sealed gas insert or prefab firebox burns clean, so the work shifts to the venting, the gasket and glass seal, the burner and logs, and the condition of the Class A metal flue inside its framed chase. Redwood Shores and the later infill homes are mostly that second type. Both need eyes on them yearly; what we actually do differs a lot.

Call (415) 738-4058 for a same-day estimate.

What is included when you service a gas fireplace?

We test the pilot and the thermocouple or thermopile, clean the burner ports and the pilot assembly, and check that ignition is steady rather than lazy. The glass comes out for cleaning and the gasket gets inspected, since a poor seal changes how the unit vents. Logs go back in the exact pattern the manufacturer specifies, because misplaced logs are the usual cause of sooting. We finish by checking the vent run, termination and chase on Heatilator, Heat & Glo, Majestic, Napoleon, Superior and Empire units.

Call (415) 738-4058 for a same-day estimate.

Suppose the inspection turns up a split flue tile or a failing liner. Where does that leave me?

The fireplace goes out of service until it is corrected, because a gap in the liner lets heat and combustion gases reach framing and wall cavities. We show you the camera footage so you can see the crack or the open joint yourself. The fix is usually a new liner sized to the appliance, either stainless running the full height or a cast-in-place system, and we handle that work. What we do not do is masonry or brickwork, so if the problem is a spalling chimney stack or a failed crown, we tell you plainly and you bring in a mason.

Call (415) 738-4058 for a same-day estimate.

The damper will not close all the way. Can you deal with it, and what drives the price of a job like this?

Usually yes. Most stuck dampers in older Redwood City chimneys are seized from rust, creosote on the seat, or a bent plate, and cleaning the seat and freeing the pivot gets them working again. When the frame is too far gone we fit a top-sealing damper at the flue instead, which also helps against the marine layer and salt air off the Bay. On cost, what moves the number here is how many stories and how steep the roof is, whether the flue is masonry with clay tile or metal in a framed chase, how much buildup there is, and whether we are sweeping or replacing hardware like a cap or damper. The estimate is free and you approve the number in writing before we touch anything. We cover Redwood City and the surrounding mid-Peninsula in San Mateo County, and same-day slots are often open.

Call (415) 738-4058 for a same-day estimate.

Have a question that's not here?

Call us and ask. We'll give you a straight answer and tell you if it's worth coming out.

Call (415) 738-4058

Or see our contact page for address and hours.